Pipe Repair Bandage
Industrial Products
Ansen Pipe Repair Bandage is a water-activated, fibre-reinforced repair tape for emergency and rapid repair of cracks and leaks. It is easy to use for emergency situations and you can even use it underwater pipes.
Specifications
Black & White 2" x 5' (5cm x 1.5m)
(1 roll pipe repair bandage, 1 pc putty and 1 pair gloves included)
​
Black & White 4" x 5' (10cm x 1.5m)
(1 roll pipe repair bandage, 1 pc putty and 1 pair gloves included)
​
Black & White 4" x 15'(10cm x 4.6m)
(1 roll pipe repair bandage, 1 pc putty and 1 pair gloves included)
​
Black & White 4" x 40' (10cm x 4.6m)
(1 roll pipe repair bandage, 1 pc putty and 1 pair gloves included)
Application
-
Pipe repair offline repairs sealing joints hazardous material spill control, reinforce thinning walls.
-
Abrasion protection
-
Structural reinforcement
-
Repair in hard to reach areas
-
Underwater repair
Chemical Resistance
Resistance
​
R
R
R
R
R
R
R
R
R
Chemical
Citric Acid <10% Crude Oil Diesel Formic Acid <10% Zinc Chloride R
Phosphoric Acid <10-20-75%
Potassium Carbonate
Sulphuric acid 30%
Hydraulic Acid
Instructions for Use
-
Minimize the flow rate and reduce system pressure
-
Roughen the area to be repaired
-
Knead the seal stick so that the 2 components mix
-
Place the seal Stick in the hole
-
Wear gloves, Open the package at a time in order to escape from causing moisture to cure the resin. Immerse wrap Seal Fiberglass Tape into the water for 3 seconds
-
Wrap the damaged area extending 2 inches (5cm) as tightly and evenly as possible, using the entire roll
-
After finishing wrapping, extend the surface to achieve good contact between layers.
Note:
Wear gloves to protect your hands before opening the package.
For steps 3 & 4, if you haven't epoxy putty, please use other sealing material to seal first, then wrap the bandage.
Make sure the epoxy putty is thoroughly mixed
Technical Data & Performance
Drying & Curing time at 20° C (68°F)
Working time: 3-5 minutes
Cured material life: 10-20 years dependent on repair quality, environmental condition, pipe temperature, etc.
Initial cure time: 7-10 minutes
Full cure time: 30 minutes
Appearance:
Single Pack - Black/White
Shelf Life: 2 years if unopened and stored in normal
condition (15-30°C/60-86°C)
Maximum Heat Resistance: 302°F
Mechanical properties
Tensile strength : 5075Pal
Pressure resistance: 400PS (Base on 10 layers)
Shore D Hardness: 70